Readers ask: How To Build A Double Fence Gate 12 Foot?

How wide should a double fence gate be?

On widths of 6′ or more, use a double swing gate. Your front house door is no bigger than 36″ so a minimum of 36″ wide gates should be used. Your appliance will not fit through the gate that you want in the house. A driveway should have 12′ minimum clearance through the gate.

What size post do I need for a 12 ft gate?

I would play it as if two gates each being 7 feet or under each, use a 3 inch diameter hinge post. If the gates are to be 10 or 12 feet in with each I would surely use a 4 inch diameter post.

How much does it cost to build a double wooden gate?

Wood Gate Average Costs Hiring a carpenter to build a custom wood gate could cost around $35 to $75 per hour. Installation of wood fence gates costs roughly $4 to $8 per linear foot (approximately $20 to $60 for a single gate and $50 to $125 for a double gate ).

You might be interested:  How To Keep A Dog From Digging Under A Fence?

Can you make a fence panel into a gate?

Rather than building or buying a new gate, you can convert a fence panel to serve as the new gate. Most fence panels easily convert to a gate. If the fence is weak or the panel is not sturdy, you may nail an additional 2-by-4 or 2-by-6 to the back of the panel for additional support.

How wide should a gate be for a fence?

We typically recommend that your gate area be no wider than four feet when building a single gate. Anything wider than that and you will need to measure and build a double gate, which meets in the middle.

Should a fence gate open in or out?

Your gate should always swing inward. You want the gate to move towards private space, not out to the public. Single gate hinges work on either side. If you have a gate swinging on a sloping hill, you might need to place hinges on a different place, like the downhill posts.

What is the typical width of a fence gate?

Since only people are going to be walking through, they are usually 3 to 4 feet wide. Their height and material often correlate with the fence they happen to be connected to. Manufactured gate heights are usually 4 to 5 feet, but can also be made higher or lower depending on the fence they’re attached to.

How deep do gate posts need to be?

You need to first dig a hole a good 2ft 6 (760mm) to 3ft (915mm) deep (this gets the base of the post below the level that frost penetrates, once below this level the ground is less likely to move as much!

You might be interested:  Quick Answer: How To Build A Double Gate For A Privacy Fence?

How much space should be between post and gate?

For gates with standard 2×4 framing and 4×4 posts, leave a 1/2- to 3/4-inch space between the latch post and the gate frame. On the hinge side, it will depend on the hardware you use. About 1/4 inch is usually sufficient.

How much should a fence gate cost?

If you need a gate, the price is around $500 for a pedestrian one, while the price for a double drive gate is around $1,300 including gate installation costs. As you already know, the total cost depends on various factors such as the height and style of the fence.

How long does it take to install a gate?

It depends on the size of the job, but most fences can be installed in one to three days. There is no reason to have to wait days or weeks between when the fence posts are installed, and when the rails, gates, and the rest of the job is completed.

Leave a Reply

Your email address will not be published. Required fields are marked *