- 1 Can you put a vinyl fence on concrete?
- 2 Can you install a fence on concrete?
- 3 Do vinyl fence post need gravel under?
- 4 How do you attach a vinyl fence to a block wall?
- 5 Can you install vinyl fence over existing posts?
- 6 How do you put a fence post in concrete?
- 7 How do you remove vinyl fence posts from concrete?
- 8 Can you install vinyl fence without wood post?
- 9 How do you increase the height of a block wall?
- 10 Should fence post be attached to House?
Can you put a vinyl fence on concrete?
Manufacturers unanimously require vinyl fence posts to be installed into a concrete filled post hole. Setting vinyl posts into concrete provides a consistent footing to ensure the posts will remain inline and true for years to come. Concrete should fill the post hole up to 3-4 inches from the top.
Can you install a fence on concrete?
When installing a fence on an existing concrete pad, some fence installers prefer to core drill through the concrete and set posts the traditional way – embedded in concrete underground. Using a rented core drill, you can drill a hole through your concrete slab for each fence post.
Do vinyl fence post need gravel under?
Although depth requirements vary depending on soil conditions and climate, you generally want a third of the post length to be in the ground. You also need to account for an additional 6 inches of gravel, which provides a base that will help drain water away from the post.
How do you attach a vinyl fence to a block wall?
You can attach a vinyl fence to a cinder block wall using specialized brackets. When the brackets are attached to the cinder block wall, you can slide the vinyl fence rails directly over them for hanging. Brackets vary in size to accommodate a wide range of vinyl fence rails.
Can you install vinyl fence over existing posts?
It is possible to reuse existing fence posts and sleeve vinyl posts over them, however it is usually impractical to do so for a vinyl fence installation. Most vinyl fences have 6′ wide sections (measured center to center of posts) whereas most wood fences are installed with the posts 8′ +/- apart.
How do you put a fence post in concrete?
How to Set Fence Posts in Concrete
- 6 – Pour in gravel. After you have your post hole dug to the proper depth, pour in a few inches of gravel in the bottom of the hole.
- 7 – Place and brace your post. Set your post in the hole.
- 8 – Pour in concrete.
- 9 – Let it cure.
How do you remove vinyl fence posts from concrete?
Most vinyl fence corner posts are sleeves placed over 4-by-4-inch posts and set in concrete.
- Wet the ground thoroughly around the vinyl fence posts with a garden hose.
- Dig straight down on each side of a post with a posthole digger.
- Continue digging on all four sides until you reach the bottom of the post.
Can you install vinyl fence without wood post?
Depending on your local soil and weather conditions, the fence may have been installed without internal post support (if so, you’re in luck!). If you are installing a new fence know that most vinyl fence manufacturers recommend installing the hollow post with a wood or metal insert to add stability.
How do you increase the height of a block wall?
Increase Block Wall Height
- Remove the column caps.
- Drill into the existing wall and epoxy in 1/2″ rebar every 8″ to a height of 1″ shorter than the desired height of the finished wall.
- Mortar the first layer of blocks into place.
- Fill the blocks with concrete.
- Mortar the second layer of blocks into place where needed.
Should fence post be attached to House?
Don’t attach the fence to the house. Aside from putting holes in your siding (not a good thing), your fence and your house will most likely move differentially. The attachment could result in a tear of the siding, which would be a bad thing.