Question: How To Install High Tensile Fence?

How far apart should fence posts be for high tensile fence?

As a rule of thumb, line posts are spaced about 30-feet apart but it depends on many factors including the number of wires in the fence, the terrain, as well as type and number of animals being controlled. Increasing the distance between posts reduces the cost of the fence.

How tight should a high tensile fence be?

– Over-tensioning hi-tensile wire: Hi-tensile wire needs only between 150 to 200 pounds of tension. If you are used to putting up barbed wire, then you would normally put about 300 to 350 pounds of tension on it. So, don’t over tension hi-tensile wire. This is normally the last step in putting up your fence.

How far can you pull high tensile wire?

You will need at least one strainer for every wire in each section you pull. You can have a maximum of 4000 feet between strainers. Reduce pull by 500 feet for each corner. Also reduce distance pulled if working over rough terrain.

You might be interested:  FAQ: How To Make A Rope Fence?

What do I need for high tensile fence?

Building High-Tensile Fence

  1. Dig holes for the corner posts.
  2. Set corner posts.
  3. Build braces.
  4. Attach insulator tubes to corner post.
  5. Unroll the wire.
  6. Lay out line posts.
  7. Attach the insulator tubes and wire on the second corner, before you walk (or drive) back to the first corner.
  8. Cut and attach wire on the first corner.

What is a good distance between fence posts?

Typically, fence posts are spaced between six and eight feet apart. The corner posts are set first. To align all of the posts in between, stretch a line from each corner post to work as your guide.

How much does it cost to install high tensile fence?

High-tensile wire fencing is the least expensive option at $3.50 to $8 per foot. Pipe fencing costs $10 to $15 per foot, including installation. The cost to install a wooden fence ranges from $12 to $17 per foot, while vinyl costs $14 to $28 per foot. You’ll pay between $2 and $20 per foot for materials.

Will high tensile fence keep goats in?

Fencing is the most critical factor in raising goats on pasture. Goats can be controlled with four to five strands of high- tensile electrified wire. The wire spacings can vary from 6 to 8 inches near the ground to 8 to 12 inches for the top strands.

Can you electrify high tensile wire?

This electric shock keeps the animal off the fence; electrified high tensile fences are not susceptible to animal pressure. The class lll galvanization used on a 12-1/2 gauge, high carbon, high tensile fence wire inhibits rust from forming for years and years.

You might be interested:  How To Install Board On Board Fence?

What is high tensile wire used for?

High tensile wire is regarded as the most significant improvement in farm fencing since the introduction of barbed wire in 1874. While relatively new in the US, it has been used to effectively control cattle, sheep, and other livestock on ranches in other countries for over 50 years.

What is high tensile wire fencing?

Hi-tensile fencing is made of smooth wire, and generally consists of four to 10 strands, depending on the animals that you’re fencing in. Hi-tensile fencing can be used in place of barbed wire; in fact, it’s generally more economical than other fences and has a longer life expectancy. And, it’s easier on livestock.

What is high tensile field fence?

High tensile wire allows you to use a smaller diameter wire instead of a thicker, low carbon wire. Once a high tensile fence is properly installed, it will remain tight for years and require very little maintenance over time. The 50-Year Fence is designed to be the strongest, longest lasting product on the market.

Leave a Reply

Your email address will not be published. Required fields are marked *