- 1 Can you make a gate out of a vinyl fence panel?
- 2 How wide can a vinyl fence gate be?
- 3 How much does it cost to put in a fence gate?
- 4 Do you put concrete inside vinyl fence post?
- 5 How do you reinforce a vinyl fence gate?
- 6 Can you install vinyl fence over existing posts?
- 7 How wide can you make a fence gate?
- 8 What is a standard fence gate width?
- 9 How much space should be between post and gate?
- 10 Are vinyl fence posts hollow?
Can you make a gate out of a vinyl fence panel?
Many manufacturers offer kits that can be used to construct a gate from a fence panel. Typically, all you need to do is cut down the panel, then add the gate kit components with vinyl cement. Other manufacturers require that you purchase a specific gate panel of a standard width.
How wide can a vinyl fence gate be?
Aluminum and vinyl fence sections are sold in sections, 6′, 7-1/2′, and 8′ wide depending on style.
How much does it cost to put in a fence gate?
If you need a gate, the price is around $500 for a pedestrian one, while the price for a double drive gate is around $1,300 including gate installation costs. As you already know, the total cost depends on various factors such as the height and style of the fence.
Do you put concrete inside vinyl fence post?
Manufacturers unanimously require vinyl fence posts to be installed into a concrete filled post hole. Setting vinyl posts into concrete provides a consistent footing to ensure the posts will remain inline and true for years to come. Concrete should fill the post hole up to 3-4 inches from the top.
How do you reinforce a vinyl fence gate?
Really easy fix for sagging gates where the gate panel itself is sagging. Simply cut a piece of heavy gauge vinyl gate bracing and attach with stainless steel self tapping color coded screws (available at Bryant Fence). For vinyl privacy gates wider than 5′ you may have to add a secondary diagonal brace.
Can you install vinyl fence over existing posts?
It is possible to reuse existing fence posts and sleeve vinyl posts over them, however it is usually impractical to do so for a vinyl fence installation. Most vinyl fences have 6′ wide sections (measured center to center of posts) whereas most wood fences are installed with the posts 8′ +/- apart.
How wide can you make a fence gate?
Next consider the width of the gate. A single gate should not be built much wider than 42 inches, or 3.5 feet. A wider gate will lower the angle of the cross-brace and the gate will sag as described above. To ensure a cross-brace angle of greater than 45 degrees, the door height must be greater than the width.
What is a standard fence gate width?
Since only people are going to be walking through, they are usually 3 to 4 feet wide. Their height and material often correlate with the fence they happen to be connected to. Manufactured gate heights are usually 4 to 5 feet, but can also be made higher or lower depending on the fence they’re attached to.
How much space should be between post and gate?
For gates with standard 2×4 framing and 4×4 posts, leave a 1/2- to 3/4-inch space between the latch post and the gate frame. On the hinge side, it will depend on the hardware you use. About 1/4 inch is usually sufficient.
Are vinyl fence posts hollow?
Some vinyl fence manufactures hollow posts that are a true 4″ square or 5″ square posts. Although these vinyl posts will fit over the wood posts, they will not fit tight, requiring you to shim the difference for a tight fit.